Publicidad
OP5
OP6
.04 in
(1~2mm)
OP7
28
(1)
(1)
English
8. Operation
6. Move the choke lever downward to open the choke.
And restart engine. (OP3)
7. Allow the engine to warm up for several minutes
before starting operation.
NOTE
1. When restarting the engine immediately after
stopping it, leave the choke open.
2. Overchoking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
■ STOPPING ENGINE (OP4)
1. Release the throttle lever and run the engine for a
half minute.
2. Shift the ignition switch to the STOP position. (OP4)
IMPORTANT
• Except for an emergency, avoid stopping the engine
while pulling the throttle lever.
■ ADJUSTING THROTTLE CABLE
• The normal play is 1 or 2mm when measured at the
carburetor side end. Readjust with the cable adjuster
as required. (OP6)
(1) cable adjuster
■ ADJUSTING IDLING SPEED (OP7)
1. When the engine tends stop frequently at idling
mode, turn the adjusting screw clockwise.
2. When the cutting head keeps rotating after releasing
the trigger, turn the adjusting screw counter-
clockwise.
(1) idle adjusting screw
NOTE
• Warm up the engine before adjusting the idling
speed.
Publicidad
