Impecca FANFAIR FSF-1815 Guia Del Usuario página 9

ASSEMBLING THE FAN AS A DESK FAN
Assemble the desk stand as shown in the diagrams below
1. Connect the middle tube with the right and left curved tubes. Secure with the screw,
then use four screws to fasten the rubber end (R) on the pipe base.
2. Use the screw and nut to attach the motor to the curved tube and base.
ASSEMBLING THE FAN AS A WALL FAN
1. Assemble the desk fan as described above
2. Use screws (M) to attach the two hooks (O) onto the wall where you want to posi-
tion the fan
3. Hang the fan base on the hooks
Wall
Position
OPERATING THE FAN
Ensure the fan is plugged in, then switch on the fan by selecting one of the three speeds
(1 -3). '3' is the fastest speed. '0' switches the fan off.
To oscillate the fan, push down on the oscillation knob (F) located on top of the motor
(E). Pull the knob back up to stop the oscillation.
To adjust the fan height, loosen the height adjustment nut (J), extend the shaft to the
desired height, then re-tighten.
Left Iron Plate
Nut
Hook
Right Iron Plate
Screw
9