Publicidad
Idiomas disponibles
Idiomas disponibles
•
Examine the trigger for correct operation.
•
Examine the power button for correct operation.
To install the battery pack
•
Align the ribs of the battery pack with the slots in the
battery compartment. Push the battery pack into the
battery compartment until you hear a click.
•
To remove the battery pack, push and hold the
battery release button and pull out the battery pack.
To start the motor
1. Install the battery pack. See
pack on page 8 .
2. Push the power button until the light is on.
3. Squeeze the trigger to operate.
•
Squeeze the trigger lightly for lower speed.
•
Squeeze the trigger more for higher speed.
4. Use the product.
To stop the motor
1. Release the trigger.
2. Push the power button until the light is off.
To change the power mode
The power mode of the product can be changed while
the product is in operation. There are 2 power modes:
1. Standard mode - Saves energy and maximizes run
time. Standard mode is applicable for most tasks.
Note: The product is set to Standard mode when
started.
2. Boost mode - The product operates at high speed in
Boost mode. Boost mode runs at maximum power
for tasks that are not easy. To start Boost mode,
push the Boost mode button until the light is on. To
stop Boost mode, push the Boost mode button until
the light is off.
Note: If the trigger is released during operation, the
product starts in the last mode. If the product
automatically stops, or if the operator pushes the power
button, the last used mode is erased from memory. The
product is set to Standard mode again when started.
8
To install the battery
To start the digital cruise control
The digital cruise control lets you set and hold a blower
speed without the trigger.
1. Hold the trigger at the necessary position and
engage the digital cruise control.
2. Release the trigger after the digital cruise control is
engaged.
Note: While the digital cruise control is
engaged, the trigger can be pulled again
to increase speed. After releasing the
trigger, the digital cruise control reverts
to its last position.
3. Disengage the digital cruise control to continue usual
operation of the product.
Battery state of charge LED
The status of the battery pack is shown until you pull the
trigger. When you release the trigger, the status of the
battery pack is shown again.
The number of LEDs that are on show the current
charge level of the battery pack.
LED lights
Battery status
All Green LEDs
Fully Charged (100% - 76%)
come on
LED 1, 2 and 3
The battery pack is 75% - 51%
come on
charged.
LED 1 and 2
The battery pack is 50% - 26%
come on
charged.
LED 1 comes on The battery pack is 25% - 6%
charged.
LED 1 flashes
The battery pack is 5% - 0% charg-
ed.
Note: If the motor stops and the power LED stays on,
push the button on the battery pack. For possible
TROUBLESHOOTING on page 9 .
solutions, see
Note: When the battery pack is fully discharged, the
motor stops immediately.
Note: The motor automatically stops if the battery pack
or motor controller is too hot during heavy operation. Let
the motor and battery pack cool. The product then
resets.
406 - 002 - 20.11.2017
Publicidad
