Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Do not fully tighten screws during assembly. Only tighten when all parts are installed in place.
1.
Unscrew two screws from each side, located behind the side
flanges. Keep them for later use.
Caution: Do Not let front face panel fall forward once the
screws are removed. This could break the glass or lead to
damage or injury.
2.
Gently lean the top of the face panel away from the body.
Make sure to support the face panel so it does not drop
totally forward. Unplug the wires that connect the control
panel.
7
Publicidad
