Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 18
6. Place the door on a protected flat place so that the glass
door will not be damaged.
7. Follow the steps below to re-attach to the oven door
(Fig. 19):
− Insert the hinge into the top slot as shown in Fig 19
− Open the door to its fully open position as shown
b
in Fig 19
. Ensure the hinge buckle has released from
the lever as shown in Fig 19
a
Fig. 19
Replacing the Oven Light
1. Disconnect the oven from the power supply by the
electrical mains or fuse.
2. Ensure the oven has cooled before servicing the oven
light.
3. Remove the glass cover of the lamp-holder. (Fig. 20)
Fig. 20
a
.
c
.
c
Hinge
Lever
b
4. Remove the lamp and replace with a lamp resistant to high
temperatures (572
F) with the following characteristics:
o
- Voltage: 12V
- Wattage: 20W
- Type: G4
- Lamp Type: Halogen
5. Replace the glass cover.
6. Reconnect the power to the oven.
To reorder the Furrion oven light bulb replacement, please
call Furrion service for assistance.
Replacing the Control Knob LED
1. Disconnect the oven from the power supply by means of
the switch used to connect the appliance to the electrical
mains or fuse.
Grasp and pull out the control knob with the broken LED
light. (Fig. 21)
Fig. 21
.
2. Remove the two screws holding the LED light using a
Phillips screwdriver. (Fig. 22)
Fig. 22
10
Publicidad
