Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 7
4. Secure the vent cover onto the vent assembly with the six
screws provided (M3 x 8mm). (Fig. 8)
Fig. 8
Cooktop Installation
This oven is designed and can be used with a Furrion gas
or electric cooktop, please refer to corresponding cooktop
instruction manual on how to construct the cabinet and install
the cooktop over the oven. (Fig. 9 & Fig 10)
Fig. 9
Fig. 10
Furrion Gas Cooktop P/N: FGH4ZSA
Representative Illustration
Furrion Electric Cooktop P/N: FIH2ZEA
Representative Illustration
Electrical Connection
● The power supply of this oven is 12V. Connect the
components below separately. (Fig. 11)
NOTE: Ensure to connect the wires with the correct
Gas Pipe
polarity. Black is "+" and White is "-".
Cavity
● 12V power for: Igniter, Oven Light, Cooling fan, Electronic
Timer & Display, 140
F (60
o
− Feed the cable through the electrical cord cutout on
the upper rear-right corner of the cabinet, use a 15A
fuse at the power source for protection.
− The nameplate is located on top of the oven, refer to
the label for the technical specifications.
DC12V+
Micro Switch 1
Micro Switch 2
Igniter
DC12V-
Fig. 11
Gas Connection
WARNING
Gas supply pipe must be installed with clearance from
knives contacting or cutting gas lines.
Connect a propane supply line with a 3/8" Flare Female
connection to the gas oven in the upper left rear corner of
the cabinet. (Fig. 12) Tighten the gas line joint to the gas oven
using 2 wrenches.
IMPORTANT: Leave adequate space around the gas supply
pipe in case of bend or damage during installation. Make sure
the gas supply pipe cannot contact any moving parts after
installed. Be sure all openings in the cabinet around the gas
line are sealed at time of installation.
Fig. 12
Cable Cavity
C) Thermostat Control.
o
1
140°F(60°C) Normally Open Thermostat Control
Micro Switch 2
+12V IN
+12V OUT
Lamp
LED
GND IN
LED
LED
Furrion Electric Cooktop P/N: FIH2ZEA
FAN
6
Publicidad
