Publicidad
Idiomas disponibles
Idiomas disponibles
Technical Data
Code
Description
Discs
Voltage
Frequency
Current
Power
Speed
Duty cycle
Conductors
Insulating
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING
Power Requirements
WARNING
Tools with double insulation and reinforced insulation
eliminate the need for a cord of 3 parts grounded or an electric power
system grounding.
"The male connection plug may only be connected to a socket of the same
technical characteristics of the plug on"
WARNING
When using an extension cable, verify the gauge is enough
for the power that your product needs. A lower gauge cable will cause voltage drop in the line, resulting in
power loss and overheating. The following table shows the right size to use depending on cable's length and
the ampere capability shown in the tool's nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
11 000 RPM
H05VV-F 2 x 0.75 mm
Class II
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE-2006
ESMA-4-1/2P2-2
22360
Angle grinder
4
/
"
1
2
220 V
50 Hz / 60 Hz
2.8 A
0.93 Hp
Screwed thread size
20 minutes work per 10 minutes idle.
Maximum 1 and a half hour hours per day.
with insulating temperature of 221 °F
2
IP Grade:
Power cord grips used in this product: Type "Y".
Build quality: Reinforced Insulation
Thermal insulation on motor winding: Class E
Extension gauge
from 5.9' to 49.2'
18 AWG( * )
16 AWG
14 AWG
8 AWG
M14
IP20
Authorized Service Center.
|
higher than 49.2'
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3
Publicidad
