Publicidad
Idiomas disponibles
Idiomas disponibles
• Disconnect the plug from the power outlet before cleaning.
• Never use water or other type of liquids. Use only a brush.
• Clean after each use with compressed air or a brush. Pay special attention to
the ventilation slots.
• Double-check the entire tool`s components are properly fixed.
• The housing shall not be cracked or damaged.
• Double-check the power cable is not cut or peeled.
• After a prolonged use the grease from the head of the tool must be changed
at an Authorized Service Center
Repairs
Use only spare parts and accessories recommended by the manufacturer. In
the event the tool is not working repairs should be carried in a
Authorized Service Center.
Carbon brush replacement
• Carbon Brushes should be periodically checked and when worn, replaced
always in a
• After replacing the carbon brushes request to inspect if the new carbon
brushes can move freely in the carbon housing. Also request to run the tool 5
minutes to make even the contact with the carbon brushes and the commuter.
• Use only original
the hardness and resistance adequate for each type of motor. Carbons that are
out of specification could damage the motor.
• Both carbons should be changed simultaneously.
Storage
Neatly store the tool in a dry place and protected from dust and water .
8
ENGLISH
.
Authorized Service Center.
spare carbons specifically designed with
Maintenance
Publicidad
