Publicidad
7.
System Settings
Connection Settings: Switch between control mode and audience mode and link devices.
General Settings: Set the screen brightness, whether to display the front sight, ratio and
transparency of the safety frame.
About, Help: View information such as the version and SN. Get support from video tutorials.
8.
Audio Gain
9.
Monitor Volume
Listen to the audio only if an audio receiving device is connected to the 3.5mm headphone
jack.
10. Record Button and Timecode
Tap the button to start or stop shooting. Only video recording is supported.
11. LUT
12. Playback
Tap to preview the pictures and videos stored in the Ronin 4D.
13. Exposure Aid/Focus Aid*
False Color: When enabled, the live view will be displayed in false color.
Waveform: When enabled, the bottom of the screen will display the waveform of the
exposure values.
Zebra: When enabled, the overexposed areas in the image will be displayed in zebra crossing.
Adjust the level proportion of the zebra display using the slider under the option.
Peaking: Enable the peaking display and set the display color of the color peak or the
acutance percentage of the acutance peak.
Depth Waveform: When enabled, the right of the screen will display the depth map of the
live view in its top view.
The settings mentioned above are same with the ones for the Ronin 4D ultra-bright main
monitor. Refer to the Ronin 4D User Manual for details.
14. Focus Ruler
15. Safety Frame
Users can set the ratio of the safety frame and the transparency of the area out of the
frame.
* To adjust the shooting parameters, start/stop shooting, configure exposure aid/focus aid, make
sure that remote control is enabled in the Ronin 4D ultra-bright main monitor.
Firmware Update
Update the monitor using the DJI Assistant 2 (Ronin Series) software.
1. Power on the device. Connect the device to the computer using a USB-C cable.
2. Launch DJI Assistant 2 (Ronin Series) and log in with a DJI account.
3. Select the device and click Firmware Update on the left side of the screen.
4. Select the firmware version.
5. The firmware will be downloaded and updated automatically.
6. The device will restart automatically after the firmware update is complete.
Publicidad
