Baby Trend TS13D Serie Manual De Instrucciones página 14

Idiomas disponibles

THE INFANT CAR SEAT

WARNING:

or sliding out, always use the Infant Car Seat harness.

ATTENTION: CS01 EZ-Lift, CS02 EZ-Lift PLUS and CS03 EZ-Lift PRO

Infant Car Seats must attach to the module of the strollers front seat.

These models require child tray and seat back adjustment to the most

reclined position.

Align the car seat module to the inner frame connectors. Carefully rest

the car seats lower rear against the angle point of the tray. Latch the

module into the stroller frame. Press down firmly for the click.

ALWAYS ensure that the car seat is properly connected and locked onto

the stroller before each use by lifting up on the car seat handle (Fig.14a).

Always use the short clip to secure the infant car seat to the stroller

(Fig. 14b).

NOTE: To make seat position adjustments refer to step 13.

A A n n g g l l e e P P o o i i n n t t

" " C C l l i i c c k k " "

Avoid serious injury from falling

Fig. 14a

Removing the car seat

NOTE: Set handle to the carry

position (Fig. 14c).

Squeeze the release handle

located at the Top-rear of the

car seat and lift away from the

stroller (Fig. 14d).

Press

Fig. 14c

F F ig g . . 1 1 4 4 b b

Fig. 14d

Sonar