Anest Iwata SilverJet IS50 Manual De Instrucciones página 4

1. Screw the airbrush hose onto the airbrush. If you're using a brand of airbrush other than Iwata, use the appropriate adapter.
2. Screw the airbrush hose onto the compressor. Other brands of airbrush hoses will fit the compressor.
3. Choose the appropriate international plug (IS 50 SA only).
4. Plug the unit into an electrical wall outlet that meets all local government specifications.
5. Press down on the airbrush main lever before turning on the unit.
6. Turn ON the unit by pressing the on/off switch. Adjust the air pressure by turning the air bleed valve knob. Turn knob
toward "+" to increase pressure and toward "-" to decrease pressure.
NOTE ON MOISTURE: When unit gets warm from extended use, it can spit out moisture. To prevent this, use the Iwata
Pistol-Grip Moisture Filter (F A450) which is sold separately.
1. Turn off the compressor.
2. Release any leftover air by pressing down on your airbrush main lever (being careful of any excess paint) or unscrewing
your airbrush from the airbrush hose.
3. When storing your Iwata Silver Jet, you can use the electrical cord wrap feature around the base of the unit.
GETTING STARTED
ENDING A SESSION
4