Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
4
Installing the stopper and ball
rod
NOTE: In shallow cabinet installations, the ball rod (M)
may need to be shortened. Use a hack saw to cut the end
of the rod, away from the ball, to the desired length.
□
Insert the stopper (G) into the drain hole in the
sink.
□
Remove the lift rod strap (P) and spring clip (N)
from the ball rod (M).
□
Remove the ball nut (L). Insert the ball rod (M)
into the drain body (K) and through the hole
of the stopper (G). See Insert 1.
□
For easier removal and cleaning, rotate the
stopper (G) 90 degrees so that the ball rod (M)
does not go through the hole in the stopper (G).
See Insert 2.
□
Secure the ball nut (L) against the hole in the
drain body (K) and tighten the ball nut (L) onto
the threaded end. Do not overtighten.
G
K
Insert 2
K
1
Insert 1
P
M
L
N
5
Installing the lift rod
□
Push the lift rod (R) through the hole in the bottom
of the faucet (A), then reattach the lift rod knob (Q).
□
Insert the lift rod (R) down into the lift rod strap (P).
Tighten the thumb screw (O).
A
1
P
6
Q
R
R
R
2
O
O
Q
Publicidad
