Samsung HW-Q60R Manual página 15

Auto Power Link
Auto Power Link automatically turns on the Soundbar when the TV is turned on.
1. Connect the Soundbar and a TV with a digital optical cable.
2. Press the Left button on the remote control for 5 seconds to turn Auto Power
Link on or off.
• Auto Power Link is set to ON by default.
(To turn off this function, hold the Left button on the remote for 5 seconds.)
• Depending on the connected device, Auto Power Link may not function.
• This function is only available in the "D.IN" mode.
Connecting a TV using an HDMI Cable
1. With the Soundbar and TV turned on, connect the HDMI cable (not supplied) as shown in the figure.
2. "TV ARC" appears in the display window of the Soundbar main unit and the Soundbar plays TV
sound.
• If TV sound is inaudible, press the
of the Soundbar to switch to "D.IN" mode. The screen displays "D.IN" and "TV ARC" in sequence,
and TV sound is played.
• If "TV ARC" does not appear in the display window of the Soundbar main unit, confirm that the
HDMI cable (not supplied) is connected to the correct port.
• Use the volume buttons on the TV's remote control to change the volume on the Soundbar.
Connect to the HDMI IN
(ARC) port of your TV.
HDMI IN
(ARC)
(not supplied)
Connect to the HDMI OUT (TV-ARC)
port of the Soundbar main unit.

HDMI Cable

(Source) button on the remote control or on the right side
ENG - 11
Bottom of the Soundbar
HDMI IN
HDMI OUT
(TV-ARC)
DC 24V
Right Side of the Soundbar
TV ARC