Velleman CAMSET27 Manual Del Usuario página 4

5. Installation
Refer to the illustrations on page 2 of this manual.
• Make sure the vehicles' engine is off and power is removed from the electrical
system. Disconnect the battery and remove the ignition key from the ignition
switch.
• Mount the LCD [A] with the mounting bracket [B] on the dashboard using the
double sided tape on the bottom of the bracket. Make sure the driver has a
clear view on the monitor.
• Connect the monitor cable [D] to the monitor. The connector fits in only one
way, do not force.
• Guide the video cable [C] to the back of the car where the camera will be
mounted.
• Drill a hole (Ø28mm) in the bumper (drill not included).
• Insert the cables [5, 6] and the camera [G] into the hole. Depending on the
location of the camera, use the adjustment rings to level the camera with the
surface of the bumper. Use the nut to secure the camera. Do not tighten it yet.
• Connect the video cable [C] to the camera [5, yellow]; connect the other end
to the monitor cable [D2, yellow].
• Connect the red wire [3] of the monitor cable [D] to the cars +12V electrical
circuit, at a location where there is only power once the ignition key is turned
(run circuit).
• Connect the black wire [4] of the monitor cable [D] to ground (GND).
• Connect the red wire [3] of power cable [E] to the reverse light circuit (+12V).
• Connect the black wire [4] of power cable [E] to ground (GND).
• Connect the other end of power cable [E] to the camera [6, black].
• Restore power to the vehicles' electrical system; insert the ignition key in the
ignition switch and turn.
• The monitor will now show the image of the camera. Verify that this image is
upright. If not rotate the camera until it is, than secure it by tightening the nut
[F].
6. Technical specifications
system
monitor size
number of pixels
video inputs
camera pick-up element
synchronization
video output
horizontal resolution
IR LEDs
min. illumination
lens angle
S/N ratio
video input signal
A/V input connections
power supply
29/09/2010
CAMSET27
NTSC
3.5" TFT
480(H) x 320(V)
1
1/4" colour CMOS
internal
mirror image
420 TV-lines
9
0 Lux when IR on
120°
>= 48dB
1.0Vpp composite video signal at 75 ohm
RCA connector
DC 12V ±1.5V
4
©Velleman nv