Publicidad
Idiomas disponibles
Idiomas disponibles
Lifting and Moving the TV
When moving or lifting the TV, read the following
to prevent the TV from being scratched or
damaged and for safe transportation regardless of
its type and size.
CAUTION
• Avoid touching the screen at all times, as this
may result in damage to the screen.
• Do not place the product on the floor with its
front facing down without padding. Failure to do
so may result in damage to the screen.
• It is recommended to move the TV in the box or
packing material that the TV originally came in.
• Before moving or lifting the TV, disconnect the
power cord and all cables.
• When holding the TV, the screen
should face away from you to
avoid damage.
• Hold the top and bottom of the TV frame firmly.
Make sure not to hold the transparent part,
speaker, or speaker grille area.
• Use at least two people to move
a large TV.
• When transporting the TV by
hand, hold the TV as shown in the
following illustration.
ASSEMBLING AND PREPARING
• When handling the TV, be careful not to damage
the protruding joystick button.
• When transporting the TV, do not expose the TV
to jolts or excessive vibration.
• When transporting the TV, keep the TV upright;
never turn the TV on its side or tilt towards the
left or right.
• Do not apply excessive pressure to cause flexing
or bending of frame chassis as it may damage
screen.
• Be sure to keep your TV upright instead of laying
it down or tilting it while moving the TV.
Setting Up The TV
You can mount your TV to a wall or attach
the stand if you wish to place the TV on an
entertainment center or other furniture.
Attaching the Stand
If you are not mounting the TV to a wall, use the
following instructions to attach the stand.
CAUTION
• Make sure that the screws are fastened tightly.
(If they are not fastened securely enough, the TV
may tilt forward after being installed.)
• Do not tighten the screws with too much force;
otherwise they may be damaged and come
loose later.
NOTE
• Remove the stand before installing the TV on a
wall mount by performing the stand attachment
in reverse.
13
Publicidad
