Casselin CFCV2 Manual página 16

5.2 Use
WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
The device must be completely removed from its packaging. All protections must be completely removed.
Remove the protective sheet from the exterior surfaces. If adhesive deposits form on the device, remove
them using a suitable solvent.
Place the device upright on a solid, flat surface capable of withstanding high temperatures.
Never place the convection oven on a flammable surface. Position this unit so as to ensure optimal air
circulation. We advise you to keep a minimum distance of 15 cm from the wall and other objects.
Do not place any object on the device.
Do not embed the appliance.
Do not install this appliance near open fires, or other heating appliances.
Do not install the device in a wet or humid place.
The electrical cable should be protected to at least 32 amps. The device must be plugged directly into a wall
outlet. Using a multiple socket will cause the device to trip.
Water connection for the CFCV2 oven
The device must be placed near a water inlet. Connect the device using a high pressure hose located at the
rear. The water pressure must not exceed 2 bars.
Before use, the device must be cleaned.
Before using for the first time, heat the appliance without food.
To do this, plug in the appliance and set your thermostat to 200 ° C and the time to 30 minutes. Do not put
food on until the convection oven has cooled down. Smoke formation and bad odors may occur, this is a
normal operating cycle.
The indicator light comes on as soon as a wheel is operated.
- When the temperature dial is engaged (grilling or convection), the indicator lights up then goes out
when the temperature is reached.
- When the cooking time dial is engaged, the indicator light comes on and the fans start to operate.
Place your products on the shelves. When using different plates, use the perforated plates so that the heat
is distributed evenly.
The appliance switches off automatically after the end of the cooking time.
Humidification for CFCV ovens2:
Humidification is activated by pressing the humidification indicator. The water is distributed by the fans on
the resistances which allows a diffusion of water vapor. Water is injected as long as the button is pressed.
The humidification button should only be pressed when the temperature is reached. Do not press the
humidification button for too long to avoid excess water.
NOTEThe device is fitted with a safety system in the event of overheating. If tripped, unplug the device and
allow it to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the temperature to drop, press the Reset button.
EN