Publicidad
Idiomas disponibles
Idiomas disponibles
28
INSTALLATION INSTRUCTIONS
Installation test (Duct check) (cont.)
Error Code
or
or
or
If the test displays four bars, check the exhaust system
for restrictions and damage. Repair or replace the
exhaust system as needed.
NOTE
When the dryer is first installed, this test should be
performed to alert you to any existing problems with
test performed during normal operation provides
more accurate information on the condition of the
exhaust duct than does the installation test, the
number of bars displayed during the two tests may
not be the same.
Do not interrupt the test cycle, as this could result in
inaccurate results.
Even if no bars are displayed during the test cycle,
some restrictions may still be present in the exhaust
system. Refer to the
this manual for complete exhaust system and venting
requirements.
Your dryer features Flow Sense™, an innovative
sensing system that automatically detects and alerts
you to blockages and restrictions in installed house-
hold ductwork. If you see the alert, clean or repair the
clean of lint buildup and free of restrictions allows
clothes to dry faster and reduces energy use.
Possible Causes
connected correctly, or house power
supply is incorrect.
tripped, or power outage has occurred.
section of
Turn off the dryer and call for
service.
Turn off the dryer and call for
service.
Check the power supply or the
connection of power cord to the
terminal block. Refer to the
for complete instructions.
the fuse capacity.
If the problem is a circuit overload, have it corrected
by a qualified electrician.
Avoid long runs or runs with multiple elbows or
bends.
Excess or crushed
transition duct
Check for blockages and lint buildup.
Solutions
section of this manual
Too many elbows or
exhaust too long
Lint buildup
or blockage
Crushed or
damaged
exhaust
Publicidad
