Solter LITHIUM LT-09 Manual De Instrucciones página 8

Charging LT-09 starter
This starter can be charged in 3 different ways: through the micro-USB port (using the supplied 4in1 USB cable) or by
14V input jack (using the mains charger or the 12V charger for vehicles). If you are charging the starter, lights flashing
will change into fixed as you gain battery charge. When the 4 lights remain fixed, charging is finished and you should
disconnect it from the charger.
1 – Connect the main USB jack of 4in1 cable to an output USB socket of the desired electronic device.
2 – Connect the micro-USB connector of 4in1 cable to input port 5V / 1A of the starter to start charging.
Or
1 – Connect the mains charger to a network socket.
2 – Connect the other end of the charger to the 14V 1A input port of the starter.
Or
1 – Connect the 12V charger to the cigarette lighter socket of your vehicle.
2 – Connect the other end of the charger to the 14V 1A input port of the starter.
Instructions to start a 12V vehicle
1 – Make sure the vehicle battery you are intending to start is 12V (otherwise, it could damage your vehicle!)
2 – Do not try to start vehicles over 2500cc with LT-09 model
3 – Briefly press the multifunction button to verify that at least there are 3 lighted indicator lights (if two or fewer lights
turn on, charge the starter before attempting to start any vehicle)
4 – Connect the red clamp to the positive (red) terminal of the vehicle battery (+) and then the black clamp to the
negative (-) terminal of the vehicle battery.
5 – Connect firmly the blue connector of the clamps into the blue socket of the starter.
6 – Try to start the vehicle
7 – Once the engine has started, disconnect the starter from the clamps (blue connectors) in less than 30
seconds and then disconnect the clamps from the battery terminals. Red clamp first and black clamp after.
8 – Leave the engine running to restore the charge of the vehicle's battery.
Do not attempt to start a vehicle for more than 5 seconds. After that time, disconnect the starter from the clamps (blue
connectors) and try again after 5 minutes.