HIKVISION DS-2XE6445G0-IZS/304 Guia De Inicio Rapido página 10


Possibly hazardous optical radiation
emitted from this product.

DO NOT stare at operating light
source. May be harmful to the eyes.

Wear appropriate eye protection or
DO NOT turn on the white light
when you assemble, install or
maintain the camera.
Transportation

Keep the device in original or similar
packaging while transporting it.
System Security

The installer and user are
responsible for password and
security configuration.
Maintenance

If the product does not work
properly, please contact your dealer
or the nearest service center.

We shall not assume any
responsibility for problems caused
by unauthorized repair or
maintenance.

A few device components (e.g.,
electrolytic capacitor) require
regular replacement. The average
lifespan varies, so periodic checking
is recommended. Contact your
dealer for details.
Cleaning

Please use a soft and dry cloth when
clean inside and outside surfaces of
the product cover. Do not use
alkaline detergents.
Using Environment

When any laser equipment is in use,
make sure that the device lens is not
exposed to the laser beam, or it may
burn out.

DO NOT expose the device to high
electromagnetic radiation or dusty
Network Bullet Camera·Quick Start Guide
environments.

For indoor-only device, place it in a
dry and well-ventilated
environment.

DO NOT aim the lens at the sun or
any other bright light.

Make sure the running environment
meets the requirement of the
device. The operating temperature
shall be -30 °C to 60 °C (-22 °F to
140 °F), and the operating humidity
shall be 95% or less (no condensing).

DO NOT place the camera in
extremely hot, cold, dusty or damp
locations, and do not expose it to
high electromagnetic radiation.
Emergency

If smoke, odor, or noise arises from
the device, immediately turn off the
power, unplug the power cable, and
contact the service center.
Time Synchronization

Set up device time manually for the
first time access if the local time is
not synchronized with that of the
network. Visit the device via Web
browse/client software and go to
time settings interface.
Reflection

Make sure that no reflective surface
is too close to the device lens. The IR
light from the device may reflect
back into the lens causing reflection.
Intended use of the camera
ATEX: II 2 G D Ex db IIC T6 Gb/Ex tb IIIC
T80°C Db
IECEx: Ex db IIC T6 Gb/Ex tb IIIC T80°C Db
Hazardous Area Classification: Zone 1,
Zone 2, Zone 21, Zone 22.
IP Degree: IP66/IP68 (2m, 2h)
8