Descargar Imprimir esta página

Hunter HEPA 20310 Serie Manual De Uso Y Cuidado página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death
or electrical shock.
1. Press POWER to turn off the air purifier.
2. Unplug air purifier or disconnect power.
3. Press the release tabs on the rear of the
air purifier. Gently pull the rear grille
away from the unit and remove.
4. Remove the 2-in-1 filter. To avoid
damage to the air purifier, do not wash
and reuse the 2-in-1 filter.
5. Clean the air purifier with a soft, damp
cloth.
6. Gently wash the rear grille in soapy
water.
NOTE: The grille is not dishwasher safe.
7. Insert the 2-in-1 filter into air purifier. See
"Filter Replacement."
First try the solutions suggested here and possibly avoid the cost of
Air purifier will not run
Check the following:
Is the air purifier turned on?
Is the 2 prong power cord plugged into a
grounded outlet?
TROUBLESHOOTING
a service call...
8. Place the bottom tabs on the rear grille
into the slots in the air purifier. Push the
top of the grille forward until the grille
locks into place.
9. Plug in air purifier or reconnect power.
10. Press POWER to turn on the air purifier.
Filter Replacement
NOTE: For the most efficient operation of
the air purifier, under normal conditions it is
recommended that you replace the 2-in-1
filter every year. See "Replacement Filters"
in the "Assistance or Service" section.
1. Press POWER to turn off the air purifier.
2. Unplug air purifier or disconnect power.
3. Press the release tabs on the rear of the
air purifier. Gently pull the rear grille
away from the unit and remove.
4. Remove and replace the filter. Install the
new 2-in-1 filter in the same direction
shown by the arrow located on the filter
frame. Install the new filter by placing it
under the tabs on the rear grille. See the
"Filter Location" illustration.
NOTE: To avoid damage to the air
purifier, do not wash and reuse the filter.
5. Place the bottom tabs on the rear grille
into the slots in the air purifier. Push the
top of the grille forward until the grille
locks into place.
6. Plug in air purifier or reconnect power.
7. Press POWER to start the air purifier.
Has a household fuse blown, or has a
circuit breaker tripped? Replace the fuse
or reset the circuit breaker. If the
problem continues, call an electrician.
Was a regular fuse used? Use a time-
delay fuse or time-delay circuit breaker.
5

Publicidad

loading