Publicidad
Idiomas disponibles
Idiomas disponibles
Information about the charger and the
charging process
1. Please check the data marked on the rating plate of the
battery charger. Be sure to connect the battery charger
to a power supply with the voltage marked on the rating
plate. Never connect it to a different mains voltage.
2. Protect the battery charger and its cord from damage.
Keep the charger and its cord away from heat, oil and
sharp edges. Have damaged cords repaired without delay
by a qualified technician at an authorized Snow Joe
Sun Joe
dealer or call the Snow Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
3. Electrical plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs with
grounded appliances. Unmodified plugs and matching
outlets will reduce the risk of electric shock.
4. Keep the battery charger, battery pack(s) and the cordless
tool out of the reach of children.
5. Do not use the supplied battery charger to charge other
cordless tools.
6. During periods of heavy use, the battery pack will become
warm. Allow the battery pack to cool to room temperature
before inserting it into the charger to recharge.
7. Do not overcharge batteries. Do not exceed the maximum
charging times. These charging times only apply to
discharged batteries. Frequent insertion of a charged or
partially charged battery pack will result in overcharging
and cell damage. Do not leave batteries in the charger for
days on end.
8. Never use or charge batteries if you suspect that it has
been more than 12 months since the last time they were
charged. There is a high probability that the battery pack
has already suffered dangerous damage (exhaustive
discharge).
9. Charging batteries at a temperature below 41°F (5°C) will
cause chemical damage to the cells and may cause a fire.
10. Do not use batteries that have been exposed to heat
during the charging process, as the battery cells may have
suffered dangerous damage.
11. Do not use batteries that have suffered curvature or
deformation during the charging process or those that
exhibit other atypical symptoms (gassing, hissing,
cracking, etc.).
12. Never fully discharge the battery pack (maximum
recommended depth of discharge is 80%). A complete
discharge of the battery pack will lead to premature aging
of the battery cells.
Protection from environmental influences
1. Wear suitable work clothes. Wear safety goggles.
2. Protect your cordless tool and the battery charger from
3. Do not use the cordless tool or the battery charger near
4. Use the battery charger and cordless tools only in dry
+
®
+ Sun Joe
®
®
5. Do not keep the battery charger in places where the
6. Protect batteries from overheating. Overloads,
7. Store the charger and your cordless tool only in dry
8. Prevent the lithium-ion battery pack from freezing. Battery
9. When handling batteries, be wary of electrostatic charge.
IMPORTANT!
Safety Instructions for Walk-Behind
Mowers
General Operation
• Read, understand and follow all instructions on the
• Do not put hands or feet near or under the machine.
• Only responsible adults who are familiar with the
• Clear the mowing area of foreign objects such as rocks,
4
moisture and rain. Moisture and rain can cause dangerous
cell damage.
vapors and flammable liquids.
conditions and at an ambient temperature of 41 – 105°F
(5 – 40.5°C).
temperature is liable to reach over 104°F (40°C). In
particular, do not leave the battery charger in a car that is
parked in the sunshine.
overcharging and exposure to direct sunlight will result
in overheating and cell damage. Never charge or work
with batteries that have been overheated – replace them
immediately, if possible.
locations with an ambient temperature of 41-105°F
(5-40.5°C). Store your lithium-ion battery pack in a cool,
dry place at a temperature of 50-68°F (10-20°C). Protect
the battery pack, charger and cordless tool from humidity
and direct sunlight. Only place fully charged batteries in
storage (charged to at least 40%).
packs that were stored below 32°F (0°C) for more than 60
minutes must be discarded.
Electrostatic discharges can damage the electronic
protection system and the battery cells. Avoid electrostatic
charging and never touch the battery poles.
machine and in the manual(s) before starting.
Always stay clear of the discharge opening.
instructions should be allowed to operate this machine.
wire, toys and other miscellaneous articles, which could
be picked up and thrown by the blade. Stay behind the
handle when the engine (motor) is running.
Publicidad
