trackilve TL-5 Manual De Uso página 14

Charge it as follows:
1. Connect the charging plug of the charging cable to the tracker with the charging
port located at the side of the tracker.
2. Connect the other end of the charging cable to the USB power adaptor and then to
the power socket.
3. Charge the tracker for a few hours. The blue light on SOS button will blink whilst
charging. When the tracker is fully charged, the light will turn solid blue.
4. Disconnect tracker from the charging cable.
Turning "ON" the tracker
Take the tracker outside so that it has the sky view.
1. Press and hold the "ON-/SOS" button for 5 seconds. The blue light on the front will
start to flash.
2. Put the tracker down and wait a few minutes. The tracker will carry out initial GPS
positioning. This is required for the device to operate correctly. The tracker will then
be ready for use and can be activated.
NOTE: this procedure is only required the very first time the tracker is turned "ON".
14 EN