Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
setUP aNd coNFigUratioN ProBleMs
1. HOW DO I CONFIGURE MY DAP-1533 WIRELESS N450 MEDIABRIDGE
POINT WITHOUT THE CD, OR CHECK MY WIRELESS NETWORK NAME (SSID) AND
WIRLESS ENCRYPTION KEY?
- connect your pc to dap-1533 using an ethernet cable.
- open a web browser and enter the address http://dlinkap
- the default username is Admin. the default password is blank (leave this box empty).
- If you have changed the password and cannot remember it, you will need to reset the product to
set the password back to default.
2. HOW DO I RESET MY DAP-1533 WIRELESS N450 MEDIABRIDGE
FACTORY DEFAULT SETTINGS?
- ensure the product is powered on.
- press and hold the reset button on the rear of the device for 5 seconds.
Note: Resetting the product to the factory default will erase the current configuration settings.
to reconfigure your settings, log into the dap-1533 as outlined in question 1, then run the
setup Wizard.
3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY WIRELESS
NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
- For every pc that needs to connect to the dap-1533 wirelessly, you will need to ensure you use
the correct Wireless network name (ssId) and encryption key.
- use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- make sure you write down these settings so that you can enter them into each wirelessly
connected pc. You will find a dedicated area on the back of this document to write down this
important information for future use.
daP-1533
®
/ACCESS
®
/ACCESS POINT TO
5
Publicidad
