Philips PRT215 Manual Del Usuario página 5

Hooking up the Audio/Video Receiver
1. Connect a set of Audio/Video cables to the A/V OUT jacks of your
Audio/Video Receiver. Connect the other end to your TV.
2. Plug the Audio/Video Receiver' s Power Supply into a 120 volt wall
outlet and plug its jack into the Audio/Video Receiver.
3. Position the Audio/Video Receiver in a convenient location such as on
top of your TV and orient the antenna so that the flat side points in the
direction of the room where you set up the Audio/Video Sender.
If your second TV is already hooked
up to a Satellite Receiver or other
A/V device:
If your Satellite Receiver or other A/V
component is connected to the TV using
A/V cables, you can connect the Audio/
Video Receiver to the free LINE IN
jacks on the component. If there are no
LINE IN jacks, you will need to use a
TV antenna splitter as described on the
next page.
PRT215-OM_H13957B.pmd 8-9
A/V component
8
If your TV does not have A/V connectors:
You can use the supplied coaxial cable to connect the TV OUT COAX
socket on the Audio/Video Receiver to the Antenna input on your TV. If
you already have an antenna connected to your TV, you will need to use a
TV antenna splitter as shown below.
Set your TV and the TV Channel switch on the Audio/Video Receiver (on
the bottom of the unit) to the same channel (3 or 4).
If you want to use your Video Sender to transmit from your Stereo
System only:
Just hook up the Video Sender using only the red and white jacks for the
right and left channels of the audio signal. Leave the yellow (video) jacks
unconnected.
9
9/5/2006, 12:05 PM