Publicidad
Idiomas disponibles
Idiomas disponibles
4 OPERATING YOUR O2+ BALANCE AIR PURIFIER
4.1 TURN THE O2+ BALANCE ON/OFF
1.
To turn on the O2+ Balance, first plug it into an electric outlet. The control panel lights
will flash twice and you will hear a beep.
2.
Press the Power Button on the control panel or on the remote to switch the appliance ON.
Once powered on, the Balance will be in AUTO mode with the fan speed setting at 2 and
air quality indicator colored green for the first 2 minutes, then it will adjust automatically.
3.
To turn OFF, press the Power Button on the control panel or remote, the appliance will
beep and the lights will power off.
4.2 MODES AND INDICATORS
4.2.1 AUTO MODE
The Air Quality Sensor automatically measures the ambient air quality. When Auto Mode is
activated, the appliance selects the most appropriate fan speed for the measured air quality for
the best possible air in the room.
1.
To turn on Auto Mode, press the Auto Button on the control panel or remote (the Auto Mode
light will illuminate).
2.
If the air quality in the room is Excellent, the appliance will operate at a low fan speed. The
appliance will automatically adjust the fan speed according to changes in the air quality.
NOTE: When the humidity level in the room is very high, it is possible that condensation can
develop on the Air Quality Sensor on the side of the appliance. This may cause the
Balance to believe the air quality is lower and cause the fan speed to operate at a
higher level. If the room has very high humidity, you may prefer to run the appliance
in Fan Speed Mode rather than Auto Mode.
Air Quality
Indicator
Blue
Air Quality
Excellent
Level
Fan Speed
Low
NOTE: The brightness of the LED lights on the control panel auto adjusts according to the
level of the ambient light.
Green
Purple
Good
Moderate
Medium
High
Red
Poor
Turbo
8
Publicidad
