Descargar Imprimir esta página

Taurus HFE1001B Manual Del Usuario página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
English
Floor Cleaner
HFE1001B
DESCRIPTION
A
ON/OFF button
B
Handle
C
Body
D
Battery indicator
E
Charging port
F
Clean water tank
G
Dirty water tank
H
Rollers
I
Parking and cleaning base
J
Charger
K
Filter protector
L
Dirty water filter
- If the model of your appliance does not have
the accessories described above, they can
also be bought separately from the Technical
Assistance Service.
USE AND CARE:
- Do not use the appliance without its rollers
correctly in place.
- Do not use the appliance if the on/off switch
does not work.
- Respect the MAX level indicator of clean and
dirty water tanks.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the appli-
ance from operating correctly.
- Use the appliance and its accessories and
tools in accordance with these instructions,
taking into account the working conditions and
the work to be performed. Use the appliance
for operations different from those intended
could result in a hazardous situation.
- Do not work on areas where there are metal
objects, such as nails and/or screws.
- Never vacuum hot or sharp objects (cigarette
butts, ashes, nails, etc.).
- Do not open the battery/ies under any circums-
tances whatsoever.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance on any part of the
body of a person or animal.
- Do not use the appliance with pets or animals.
- Recharge the battery/ies only with the charger
supplied by the manufacturer. A charger that
is suitable for one type of battery may cause
explosion or fire hazard when used with other
battery/ies.
- Use the device only with the battery/ies for
which has been specifically designed. The use
of any other battery/ies s can cause an explo-
sion or fire hazard.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
CHARGING THE BATTERY
- Caution: A new battery is not fully charged and
must therefore be charged before the applian-
ce is used for the first time.
- Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
- Plug the charger (J) into the mains.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 5 to 6 hours are needed for a
complete charge of the battery. Never attempt
to over-charge the battery (although it is re-
commended that the first charge of the battery
be of 4 hours in duration).
- Connect the charger to the jack using the
socket on the appliance. The socket is located
at the back part of the appliance. (Fig.1)
- The pilot light will come on to indicate that the
charger is charging the battery.
- When the battery is charged disconnect the
charger from the mains supply.
- NB: Do not use the appliance while it is con-
nected to the charger.

Publicidad

loading