E 2 5 5 A DJ U S TA B L E B E D B A S E
Warnings
Important: Please read all safety instructions thoroughly before using your adjustable bed base. Save these instructions
and refer back to them when needed.
Before use, carefully remove packaging and follow provided setup instructions.
Safety Instructions
Dos
•
Immediately dispose of all packing materials that may
pose a suffocation risk.
•
Only plug into a circuit with an electrical surge pro-
tection device. (The surge protection device should
be properly grounded and plugged directly into a
grounded wall outlet.)
•
Always unplug bed from outlet before cleaning or
servicing.
•
Keep cord away from moving parts and heat-
ed surfaces.
•
Talk to your doctor if you have a pacemaker. (Some
pacemakers may detect bed motion as false move-
ment or exercise.)
•
Return your base to flat before switching between
preset positions.
iii
Don'ts
•
Never operate with a damaged cord or plug.
•
Do not use outdoors or as a hospital bed. (This prod-
uct is designed solely for in-home use and has not
been tested to meet hospital standards.)
•
Do not use with oxygen or other flammable gases.
•
Do not allow children or pets to play under or on top
of the bed. Children should not operate without adult
supervision.
•
Do not exceed the weight restriction of 750 pounds.
•
Do not enter or exit the bed while raised.
•
Do not sit directly on the head or foot sections while
in raised positions.
•
Do not mix old and new batteries in the
remote control.
•
Do not mix alkaline, standard, or rechargeable
batteries in the remote control.
E 2 5 5 A DJ U S TA B L E B E D B A S E
Product Ratings
This product does not need maintenance. Please do not open the motor compartments or modify any parts. Any modifi-
cation will void the warranty.
Motor Rating
The adjustable bed base motors should not be operated continuously for more than two minutes within an 18-minute
time period. Exceeding this rating will shorten the life of the motors and void the warranty.
Power Rating
Input: AC 100-240V - 50/60Hz, 1.5 Amp
Output: DC 29V-2A
FCC Compliance
This device operates on a 2.4GHz frequency transmitter and complies with Part 15 of the FCC Rules. Operation is subject to
the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interfer-
ence received, including interference that may cause undesired operation.
To comply with the FCC Radiofrequency (RF) exposure requirements, no change to the antenna or the device is permit-
ted. Any changes could result in the device exceeding the RF exposure requirement and void the user's right to operate
the device.
Have a question or concern? Contact us.
www.maloufhome.com | customerservice@maloufhome.com | 8 0 0. 5 1 7. 7 1 7 9
iv