Publicidad
E 2 5 5 A DJ U S TA B L E B E D B A S E
How to Assemble
Part 2: Add Legs (Optional)
Skip adding legs if you prefer to place your base directly on a platform, bed frame, or the floor.
1.
Locate all leg placement locations.
2.
Hand screw all legs into the bottom of the base until secure (do not over tighten).
3.
Ensure the bottom of each leg has an end cap attached.
Part 3: Connect the Cords
With the underside of the base still visible, locate the Power Supply Cord (attached to control box), Wall Plug Cord,
1.
and Power Supply Box.
2.
Connect the Power Supply Cord to the Power Supply Box.
3.
Connect the Wall Plug Cord to the Power Supply Box.
Note: Your cords are now connected, but do not plug your base into an outlet until set up is complete.
5
2: 2
Power Supply Cord
3: 1
2: 4
Wall Plug Cord
Power Supply Box
Control Box
6
Publicidad
