RSG 400 Serie Instrucciones De Uso página 4

RSG Full Mask User Manual June 2012aw :Layout 1 12/06/2018 13:39 Page 4
RSG SAFETY B.V. 2018 (GB)
3 (GB)
The RSG full face mask can be used in two different configurations
Together with filters from. the RSG filter program.
•
Together with RSG T-Air PAPR.
•
When the mask is used with the T-Air, the manual for the relevant equipment must be
observed .
If the polluted air's oxygen content is 17-21% (volume), the mask can be used with a gas,
particle or combined filter. Use an oxygen meter to ascertain the oxygen content of the air.
Follow the filter's instructions for use carefully. The filter must be equipped with a standard
thread connection approved in accordance with EN 148-1 .
If the oxygen content of the air is less than 17% (volume), or if the gas concentration exceeds
the maximum allowable gas concentrations in relation to the gas filter class used, as shown in
table 4 (see page 10), an air-supplied respirator which is independent of the surrounding air
must be used. This equipment must be equipped with a standard thread connection
approved . in accordance with EN 148-1. Follow the instructions for use for the equipment
carefully.
If the user has certain physical features (such as a beard or thick sideboards), then the mask
might not give a satisfactorily tight fit to the face. This will also apply if spectacle frames
obstruct the facial seal. In such cases, the user carries the risk of damage to his
In areas where the use of respiratory equipment is necessary, there is often a danger of
explosion. If this is the case, then the relevant precautions must be
Leave the area immediately, check the mask and replace parts
1. The mask, parts thereof, or filters are damaged.
2. Breathing difficulties occur.
3. Dizziness or indisposition occurs.
4. Pollution can be tasted or smelt, or other irritation occurs.
The mask must never be modified or altered.
PPLIC TION/LIMIT TION
:
health.1
observed.1
if:1