Hiltron security IR8 Manual Del Usuario página 2

IR8-DT8 - User's manual
INSTALLATION
Install inside of the fixture and to mount it up to the center of the frame (you see figure), with the lens
!
of a valve turned towards the low.
Open the detector and set the base with two screws.
!
Make the connections (see under).
!
Close the cover and screw to bottom for assures the fixed of the circuit.
!
Do not install the detector near sources of heat (example: electric radiators, heaters, air
!
conditioners, flames, etc.)
! Do not partially or completely obscure the field of view of the detector.
! Also avoid the installation of shutters and internal frame.
Microwave
section
(only DT8)
IR8 - DT8
Pulses-count
(Only DT8)
The clamp M can be connected to the + INT of central alarm if you want to activate the alarm memory
function, otherwise it should be left unconnected.
WARNING: Do not touch the pyroelectric sensor with your fingers!
2
Adjustable
sensitivity
PIR
Sensor
Switch
(only for those hatched DT8)
NC
TAMPER
Operation LED
security