Publicidad
STEP 13
(x32)
Carefully turn your unit over on its front side as shown. Assure the your unit is square. Distance from
corner to corner is equal. Position back panel as shown. Flush bottom edge of back pane with bottom
edge of the bottom shelf. Align back panel squarely and nail straight into back edges as shown.
Now tighten screws in angle brackets (4) that were left loose in step 8.
Flush bottom edge of the back
panel with the bottom edge of
bottom (E).
ameriwoodhome.com
IMPORTANT! THE BACK PANEL IS A STRUCTURAL
6
PART OF THIS UNIT AND MUST BE INSTALLED
PROPERLY.
BACK
PNL
"Raw Surface Shown"
20
6
Publicidad
