Uline H-5274 Manual De Instrucciones página 5

INSTALLATION IN A SLIDING SASH WINDOW
1. Cut the adhesive type foam seals to the proper
lengths and attach them to the window frame.
(See Figure 15)
Foam Seals
(Adhesive Type)
2. Open the window sash and place the window slider
kit on the window sill. (See Figure 16) Attach the
window slider kit to the window sill. Adjust the length
of the window slider kit according to the height
of the window. Screw down the two screws on the
window slider kit. (See Figure 16) Cut the adjustable
window slider kit if the height of the window is less
than 26.6". (See Figure 17)
Window Sill
26.6"- 48.5"
Cut This Side to Fit Window
PAGE 5 OF 30
INSTALLATION CONTINUED
Figure 15
Window Slider Kit
Screws
Figure 16
Figure 17
3. Close the sliding sash securely against the window
slider kit. (See Figure 18)
4. Secure the window slider kit to the window sill.
(See Figure 18)
a. For wooden windows, use 3/4" screws for
securing.
b. For Vinyl-Clad windows, use 1/2" hex head cap
screws for securing.
Window Sill
26.6"-48.5"
5. Cut the foam seal to an appropriate length and seal
the open gap between the sliding sash and outer
window sash. (See Figure 19)
6. To secure the sliding sash in place, attach sash lock
with 1/2" screw. (See Figure 20)
Window Slider Kit
Screws
Figure 18
Foam Seal
Figure 19
Figure 20
0721 IH-5274