•
Check for any obstruction in the front or back. If you find any obstruction, turn the heater off. Unplug the
heater and wait a few minutes for it to cool down. Carefully remove the obstruction. Plug the heater in and
turn it on again by referring to the OPERATING INSTRUCTIONS.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE WARRANTY
INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER
YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR PERSONAL
INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE CONTACT US BY REFERRING TO THE SERVICE &
SUPPORT INFORMATION ON THE FOLLOWING PAGE.
CLEANING AND STORAGE
We recommend that the heater be cleaned at least once a month and before off-season storage.
•
Turn the heater off and unplug it. Allow it to cool down.
•
Use a dry cloth to clean the external surfaces of the heater. DO NOT USE WATER, WAX, POLISH OR ANY
CHEMICAL SOLUTION.
•
Clean your heater using the above-mentioned steps, then pack the heater properly and store it in a cool
dry place.
•
This heater does not disassemble.
•
The motor is factory lubricated for life, and will require no further lubrication.
SPECIFICATIONS
Model No.: LLR84163
Voltage: 120V, 60Hz
Current: Maximum 12.5 Amps
Tolerances on all specifications: Not to exceed 105%.
4