Weed Eater GHT 220 Manual De Instrucciones página 5

STOPPING YOUR ENGINE
• To stop the engine, move the ON/OFF
switch to the OFF position.
STARTING YOUR ENGINE
• Fuel engine. Move at least 10 feet (3 me_
ters) away from the fueling site.
• Hold the unit on the ground in the starting
position as shown. Support unit so the
blade is off of the ground and away from
trees, bushes, onlookers, etc.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
Throttle Lock
_i_ Thr°ffle t
Throttle
Trigge_
1. Move the ON/OFF switch to the ON posi*
tion.
2. Engage the throttle lock as follows:
• press the throttle lock-out;
• squeeze and hold throttle trigger;
• press and hold throttle lock, then
• release the throttle trigger
NOTE: Keep the throttle lock engaged until
the engine starts.
O_ OF_. Switch
3. Slowly press the primer bulb 6 times.
4. Move the chokelever tothe FULLCHOKE
position.
Primer Bulb
Choke
Lever
5. Pull starter rope handle sharply until en*
gine sounds as if it is trying to run, but do
not pull rope more than 6 times.
6. Move the choke lever to the HALF
CHOKE position.
7. Pull starter rope sharply until the engine
runs, but no more than 6 pulis.
NOTE: If the engine doesn't start after 6
pulis (at the HALF CHOKE position),
check to make sure the ON/OFF switch is
in the ON position. Move the choke lever
to the FULL CHOKE position and press
the primer bulb 6 times; pull the starter
rope 2 more times. Move the choke lever
to the HALF CHOKE position and pull the
starter rope until the engine runs, but no
more than 6 more pulls. If the engine still
doesn't start, it is probably flooded. Pro,
ceed to STARTING A FLOODED EN*
GINE.
8. Once the engine starts, allow the engine to
run 10 seconds, then move the choke lever
totheOFF CHOKE position.Altaw the unitto
run for 30 more seconds at theOFFCHOKE
position before squeezing and releasing the
throttletrigger to release the throttle lock.
NOTE: if engine dies with the choke lever
in the OFF CHOKE position, move the
choke lever to the HALF CHOKE position
and pull the rope until the engine runs, but
no more than 6 pulls.
STARTING A WARM ENGINE
1. Move the ON/OFF switch to the ON posi*
tion.
2. Slowly press the primer bulb 6 times.
3. Move the choke lever to the HALF
CHOKE posittan.
4. Engage the throttle lock as dffected in
STARTING A COLD ENGINE.
NOTE: Keep the throttle lock engaged unti_
the engine starts.
5. Pull starter rope sharply until engine runs,
but no more than 5 pulis.
6. Allow the engine to run 10 seconds, then
move the choke lever to the OFF CHOKE
position.
7. Release the throttle lock by squeezing and
releasing the trigger.
NOTE: If engine has not started, pull starter
rope 5 more pulls. If engine still does not run, it
is probably flooded. Proceed to STARTING A
FLOODED ENGINE.
-5-