Publicidad
Enlaces rápidos
MVG Neptulink Roof Mount (SC-MVG-05)
Parts List
19027
Interface Seal
19037
Base Seal
60085
M8 S/S Washer
60441
M4 x 10 Socket Cap
1
ø50mm (2")
x1
x1
x4
60440
x4
Spring Washers
26-06-19 Issue 1
101817
Black Grommet
10SC-MVG-05BC
Back Cover
Parts Required
x4 M8 x 25mm+
x4
Installation Instructions
Tools Required
x2
x1
Interface Seal 19027
1x
M8 Nylon Shoulder washer 64000
4x
(Smaller of the two)
M8 S/S Washer 60085
4x
M8 x20 Hex Bolt 60816
4x
4x Apply threadlock to
M8 threads
**Caution** Avoid any
contact of thread lock or Tef
Gel on MVG Neptulink
radome.
Blanking grommets 101817
2x
M8 Fasteners (Not Supplied)
4x
M8 Nylon Shoulder washer 64000
4x
(Larger of the two)
Base Seal 19037
1x
Hole Saw
ø50-52mm (2")
1 x 13mm Spanner
3mm Allen Key
Power drill
ø8.5mm (21/64")
Drill Bit
Tef- Gel
®
Publicidad
Manuales relacionados para Scanstrut SC-MVG-05
Resumen de contenidos para Scanstrut SC-MVG-05
- Página 1 Installation Instructions 26-06-19 Issue 1 MVG Neptulink Roof Mount (SC-MVG-05) Parts List Tools Required Hole Saw 19027 101817 ø50-52mm (2”) Interface Seal Black Grommet 1 x 13mm Spanner 19037 3mm Allen Key 10SC-MVG-05BC Base Seal Back Cover Power drill 60085 M8 S/S Washer ø8.5mm (21/64”)
- Página 2 Product has been designed speci cally for the mounting of approved marine electronics under normal boating conditions. IMPORTANT Scanstrut ne fourni pas les xations pour sécuriser ce produit à la surface de choix. Veuillez utiliser des xations appropriées pour cette opération. Scanstrut déclinent toute responsabilité pour les dégats résultant d’une installation incorrecte.