Publicidad
MA7
(2)
MA8
42
9. Maintenance
(1)
• If waste gets stuck and causes blockage around the
(1) cylinder
(2) intake air cooling vent (back)
■ PROCEDURES TO BE PERFORMED AFTER
1. Remove the muffler, insert a screwdriver into the
2. Tighten all screws, bolts, and fittings.
3. Check to see if any oil or grease has worked its way
10. Storage
• Aged fuel is one of major causes of engine starting
11. Disposal
• When disposing your machine, fuel or oil for the
English
IMPORTANT
intake air cooling vent or between the cylinder fins, it
may cause the engine to overheat, and that in turn
may cause mechanical failure on the part of the
brushcutter. (MA7)
EVERY 100 HOURS OF USE
vent, and wipe away any carbon buildup. Wipe away
any carbon buildup on the muffler exhaust vent and
cylinder exhaust port at the same time.
in between the clutch lining and drum, and if it has
wipe it away using oil-free, lead-free gasoline.
English
failure. Before storing the unit, empty the fuel tank
and run the engine until it uses all the fuel left in the
fuel line and the carburetor. Store the unit indoor
taking necessary measures for rust prevention.
English
machine, be sure to allow your local regulations.
Publicidad
