Publicidad
Idiomas disponibles
Idiomas disponibles
•
Remove the battery pack from the product when not
in operation.
•
Keep the battery pack away from paper clips, keys,
nails, screws, or other small metal objects while in
WARNING: Read the safety chapter before
you assemble the product.
To assemble the blower tubes
Note: Apply water-based lubricant on the end of the
tubes to make assembly easier.
1. Loosen the screw on the tube clamp with a
screwdriver.
2. Attach the top tube with the digital control handle to
the flexible tube.
3. Tighten the screw on the tube clamp with a
screwdriver.
4. Attach the control wire to the clips on the tube
clamps.
5. Attach the middle tube to the top tube until the tab
goes into the hole. Make sure the tubes are locked
together.
8
operation. This can make a connection between
terminals. Shorting the battery pack terminals
together can cause burns or a fire.
ASSEMBLY
6. Attach the nozzle to the front tube until the tab goes
into the hole. Make sure the tubes are locked
together.
To adjust the digital control handle
1. Turn the knob below the digital control handle
counterclockwise to loosen.
2. Adjust the digital control handle to the necessary
operation position.
3. Turn the knob clockwise to tighten.
To change the product to left-handed
operation
Note: Do not cause damage to the wires below the
covers. Damaged wires can cause the product to not
operate correctly.
1. Use a screwdriver to remove the screws on the rear
cover and lower cover.
2. Remove the rear cover and lower cover to access
the fan housing assembly.
369 - 002 - 17.11.2017
Publicidad
