Descargar Imprimir esta página

Munchkin MK0009-111 Manual Del Usuario página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

Important Information
INTRODUCTION
Thank you for choosing a Munchkin safety gate to help protect your family. Your gate stays
in place by creating pressure between two opposing surfaces.
For maximum security, DO NOT use this gate in any location without installing all 4 wall
cups, sticky pads, and screws provided. In some openings only 2 top wall cups can
be fitted.
Please inspect your gate immediately. If you see any damage, do not attempt installation.
Check page 17 of this manual for information on damaged products.
Assemble the gate away from small children. Some of the parts may present a choking
hazard when loose.
PLEASE NOTE: There is a gap between your gate frame and
handle. This is not a defect. This gap will close once your gate
is properly installed. Please check the gate on a regular basis to
ensure that all parts are in proper working condition.
DISCLAIMERS
Any misuse, abuse, abnormal use, excessive wear and tear, improper assembly,
negligence, environmental exposure, accident or alteration of the gate, as well as removal
or alteration of its serial number, invalidates any and all claims against the manufacturer.
Any damage to property during installation is the sole responsibility of the end user.
WARNING:
• Children have died or been seriously injured when gates are not
securely installed.
• ALWAYS install and use gates as directed using all required parts.
• STOP using when a child can climb over or dislodge the gate.
• Use only with the locking mechanism securely engaged.
• NEVER use to keep child away from pool.
• Install according to manufacturer's instructions.
• Intend for use with children from 6 months through 24 months.
• This product will not necessarily prevent all accidents. Never leave
child unattended.
4
INCLUDED PARTS
If any parts are missing or damaged, please contact our Customer Satisfaction Team
at 1-800-344 -2229.
Gate (x1)
threaded nut (x4) (Pre-installed)
2.75" (7cm)
Small extension(x1)
Medium extension(x1)
(Pre-installed)
(Pre-installed)
Wall anchor (x4)
Wall screw (x4)
TOOLS NEEDED:
• Drill
• Pencil
• Phillips screwdriver
• Tape measure
• Flathead screwdriver
Getting Started
Adjustment rod with
5.5" (14cm)
11" (28cm)
Large extension(x1)
(Included)
Wrench
Wall cup & round
sticky pad (x4)
5

Publicidad

loading