Publicidad
Idiomas disponibles
Idiomas disponibles
How To Install
D. 41" - 43.3" (104.1CM - 110CM)
1. Remove one 2.75"(7cm) extension
& one 5.5"(14cm) extension.
2. Insert one 11"(28cm) extension to the
hinge side of the gate as shown in the
image to the right.
(Proceed to page 9.)
E. 43.3" - 46.1" (110CM - 117.1CM)
1. Remove one 5.5"(14cm) extension.
2. Insert one 11"(28cm) extension to the
hinge side of the gate as shown in the
image to the right.
(Proceed to page 9.)
F. 46.1" - 48.8" (117.1CM - 124CM)
1. Remove one 2.75"(7cm)
& one 5.5"(14cm) extension.
2. Reinsert one 5.5"(14cm) & insert one
11"(28cm) extension as shown in the
image to the right.
(Proceed to page 9.)
G. 49.4" - 51.6" (125.5CM - 131CM)
1. Remove one 5.5"(14cm) extension.
2. Reinsert one 5.5"(14cm) extension
& insert one 11"(28cm) extension as
shown in the image to the right.
(Proceed to page 9.)
Please see page 16 for additional extension configurations.
8
Remove extension
(see page 9)
STEP 3: REMOVE EXTENSION
TOOLS NEEDED:
Flathead screwdriver
1. Remove the adjustment rods and plugs from the
upper and lower side of the gate you are removing
the pre-installed extension from. You may need to use
a flathead screwdriver to remove the plugs.
2. Remove the pre-installed extension by pulling out the
upper and lower extension adapters away from the
gate. Store the extension in a safe place in case you
move the gate to a wider opening in the future.
3. Reinsert the plugs and adjustment rods you removed
earlier back into the gate. Please be sure the slot on
the plug is facing down towards the floor. Adjustment
rods slide into the plug holes. They DO NOT screw.
PLEASE NOTE: Repeat these steps on the other side of
the gate to remove the second extension if required.
To add an extension, simply reverse the instructions.
How To Install
1
Bottom plug
2
3
Slot
9
Publicidad
