Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly (continued)
3
Base installation
Locate Hearth/Base (A) and set out finished side up on
the floor.
Insert one Wood Dowel (CC) into each of the pre-drilled
holes.
Using two (2) persons lift and attach the completed front
assembly from step 2 to the Hearth/Base (A). Make sure
that Wood Dowels (CC) are seated into the pre-drilled
holes in the hearth/base.
Using Bolt (AA) and Washer (BB) attach panels through
pre-drilled holes in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
Part
Description
AA
Bolt
BB
Washer
CC
Wood Dowel
CC
5
Upper panel installation
Insert one Wood Dowel (CC) into each of the pre-drilled holes.
Push the Left Upper Side Panel (I) and Right Upper Side Panel (J)
snug to the Center Upper Front Panel (H). Make sure the Wood
Dowels are seated in the pre-drilled holes.
Connect the Left Upper Side Panel (I), Right Up per Side Panel (J)
and Center Upper Front Panel (H) with Connection Plate (GG).
Tighten Screws (EE) through the pre-drilled holes.
Hardware Used
Part
Description
CC
Bolt
EE
Washer
GG
Connection Plate (pre-attached)
Qty
8
8
8
AA
BB
A
Qty
4
2
2
4
Center shelf installation
Insert one Wood Dowel (CC) into each of the pre-drilled
holes on the top edges of the Assembly from step 3.
Locate Center Shelf (G) and lay finished side up on top
of completed assembly.
From the inside, attach Center Shelf (G) using Bolt (AA)
and Washer (BB) through the pre-drilled holes in the
mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
Part
Description
AA
Bolt
BB
Washer
CC
Wood Dowel
CC
GG
CC
J
8
G
BB
AA
EE
CC
H
I
Qty
10
10
9
CC
Publicidad
