Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly (continued)
6
Center shelf installation
Insert one Wood Dowel (CC) into each of the pre-drilled
holes.
Using two (2) persons lift and attach the completed front
assembly from step 5 to the Center Shelf (G) as shown
in diagram.
Make sure that Wood Dowels (CC) are seated into the
pre-drilled holes in the hearth/base.
Using Bolt (AA) and Washer (BB) attach panels through
pre-drilled holes in the mounting blocks. HAND TIGHTEN
ONLY.
Hardware Used
Part
Description
AA
Bolt
BB
Washer
CC
Wood Dowel
AA
BB
CC
8
Back panel installation
Attach Back Panel (M) and Center Back Panel (L) to the back
of the completed assembly from step 7.
Insert screws (EE) through the pre-drilled holes in the Back
Panels to the completed assembly. Hand tighten.
Use a Phillips Head Screwdriver to tighten the bolts that were
hand tightened.
Hardware Used
Part
Description
EE
Screw
Qty
4
4
4
CC
G
Qty
37
9
7
Mantel top installation
Insert one Wood Dowel (CC) into each of the pre-drilled
holes on the top edges of the Assembly from step 6.
Locate Mantel/Top (K) and lay finished side up on top of
completed assembly.
From the inside, attach Mantel/Top (K) using Bolt (AA)
and Washer (BB) through the pre-drilled holes in the
mounting blocks. HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
Part
Description
AA
Bolt
BB
Washer
CC
Wood Dowel
CC
EE
M
Please contact 1-877-527-0313 for further assistance.
Qty
6
6
5
K
CC
AA
BB
EE
L
M
HAMPTONBAY.COM
Publicidad
