Publicidad
STEP 4
Top edges of both
parts will be flush.
L
A
End View
Be sure your parts
are positioned as
illustrated.
Position and insert locking bolts (10) of left rear leg (L) into edge holes of left panel (A) as shown.
Be sure both parts are positioned as shown. Place the hammer block on top of leg in each of the 3
locking bolt locations and give a firm strike to lock together. The locking bolt (10) will snap into the
locking sleeve (11).
IMPORTANT NOTICE: Once locked together, parts cannot be separated.
Note: A rubber mallet can be used in place of a hammer and hammer block.
ameriwoodhome.com
Hammer Block
Hole(s) in
this surface.
L
A
K
11
Publicidad
