Publicidad
STEP 6
Top edges of both
parts will be flush.
Finished Edge
Position and insert locking bolts (10) of right front leg (M) into edge holes of right panel (B) as
shown. Be sure both parts are positioned as shown. Place the hammer block on top of leg in each
of the 3 locking bolt locations and give a firm strike to lock together. The locking bolt (10) will snap
into the locking sleeve (11).
IMPORTANT NOTICE: Once locked together, parts cannot be separated.
Note: A rubber mallet can be used in place of a hammer and hammer block.
ameriwoodhome.com
Hammer Block
M
B
13
Hole(s) in
this surface.
End View
Be sure your parts
are positioned as
illustrated.
M
B
Publicidad
