Puky LAUFRAD Manual De Instrucciones página 5

SCOPE OF DELIVERY
LEARNER BIKE
1 Learner bike
2 Handle bar
INSTALLATION
MANUAL
You will need the following tools for
assembly: (The tools are not part of
the scope of delivery)
1 Allen key 5 mm
3
ca. 60 mm
1
Settings control and fine adjustment of the brake (V-brake).
Only for model LR XL. Make sure that the brake pads are
parallel to each other and that they are properly aligned with the
rim. This means that the brake pads should rest 1 mm below
the top edge of the rim. If these settings are not correct, loosen
the fastening nut of the brake pad (1) and align as described
above. To do so, pull the brake lever and re-tighten the fastening
nut (5-8 Nm).
GB
43822_bda_learnerbike_2202.indd 5 43822_bda_learnerbike_2202.indd 5
1
10 Nm
Insert the handlebar into the steer tube and tighten the screw.
Please pay attention to the marking of the minimum insertion
4
1
≤1,5 mm
Brake cable tension is adjusted at the anchor nut (A) so that
each brake pad maintains a distance of 1.5 mm to the rim. If
an adjustment needs to be made, the protruding wire end
should then be refastened to the brake.
2
1
2
!
After loosening the saddle clamp, you can pull out the saddle
(observe minimum insertion depth!). Then retighten (5-8 Nm).
depth. The brake on this bike has already been installed and adjusted
5
A
!
≤1,5 mm
Now centre the brake arms by turning the adjusting screw. You
It is important that the brake levers are actuated several
times so that the tension of the brake arms is evenly distrib-
uted to both sides and the settings take effect. The brake/
5-8 Nm
!
by PUKY.
+
+
1 1
_
will need a crosstip screwdriver for this.
rim contact must be identical on both sides.
08.03.2022 09:17:55 08.03.2022 09:17:55
5