STEP 17
6
Assure that our unit is square.
Distance from corner to corner
must be equal as shown.
ameriwoodhome.com
12
IMPORTANT! THE BACK PANEL IS A STRUCTURAL PART OF
6
THIS UNIT AND MUST BE INSTALLED PROPERLY.
Carefully turn the cabinet over on it's front side.
Align squarely with outer edges. Flush bottom
edge of back panel (N) with the bottom edge of
(x12)
(x16)
the bottom (D). Use screws (6) to assemble to
left rear leg (J) & right rear leg (L). DO NOT FULLY
TIGHTEN. Adjust accordingly. Use nail (12) and
nail straight into back edges of bottom (D) & top (C).
12
Tighten screws.
N
B
25
raw surface
D
Flush bottom edge of the back
panel with the bottom edge of
bottom (D).
6