Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

8" FIXED CENTER
CONCEALED
WIDESPREAD
B-2300, B-2800,
B-2900 SERIES
Patent # 7,472,434
Installation and
Maintenance
Instructions
Limited One Year Warranty
T&S warrants to the original purchaser (other than for purposes
of resale) that such product is free from defects in material and
workmanship for a period of one (1) year from the date of purchase.
During this one-year warranty period, if the product is found to be
defective, T&S shall, at its option, repair and/or replace it. To obtain
warranty service, products must be returned to.....
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other transportation charges of
the product to T&S and the return of repaired or replaced product to
the purchaser are the responsibility of the purchaser. Repair and/or
replacement shall be made within a reasonable time after receipt by
T&S of the returned product. This warranty does not cover items which
have received secondary finishing or have been altered or modified
after purchase, or for defects caused by physical abuse to or misuse of
the product, or shipment of the products.
Any express warranty not provided herein, and any remedy for Breach
of Contract which might arise, is hereby excluded and disclaimed.
Any implied warranties of merchantability or fitness for a particular
purpose are limited to one year in duration. Under no circumstance
shall T&S be liable for loss of use or any special consequential cost,
expenses or damages.
Some states do not allow limitations on how long an implied warranty
lasts or the exclusion or limitation of incidental or consequential
damages, so the above limitations or exclusions may not apply to you.
Specific rights under this warranty and other rights vary from state to
state.
P/N:
098-016898-45 Rev. 2
DATE:
11-08-10
DRAWN:
TEH
CHECKED:
JRM 11-12-10
APPROVED:
JHB 11-12-10
19
20
21
15
8
4
13
5
12
6
16
7
14
10
11
1
9
Option B: Contains low-profile escutcheon to accommodate
push button metering, pivot action metering, alpine, dome,
3-wing, fast self-close and wrist action metering.
19
20
Option B
17
24
23
8
3
2
2
22
Parts List
1
Base Faucet Assembly
2
Side Flange Nut
3
C-Washer
4
Center Flange Nut
5
Compression & Nut Fitting
6
Compression Nut
7
Compression Fitting
8
Center Shank:
Center Shank, Swivel
Center Shank, Rigid
9
Coupling Nut
12
Escutcheons:
Escutcheon, Bell
Escutcheon, Metering
22
Hanger
19
Rigid & Swivel Goosenecks
20
Aerators:
55/64"-27 Female Threads
3/8" NPSM Male Threads
13/16"-27 Male Threads
Stream Regulator, Plain
Stream Regulator w/ Screen
Sidespray & Hose Assembly
21
Star Washer, Anti-Rotation
Cartridge Assemblies
10
Cartridge, Hot Eterna Teflon
Cartridge, Hot Cerama
11
Cartridge, Cold Eterna Teflon
Cartridge, Cold Cerama
Wrist Action Metering
18
Hot Eterna Teflon - Short
23
Push Button Metering
24
Pivot Action Metering - Hot (shown)
25
Pivot Action Metering - Cold (shown)
25
Handle Assemblies
23
13
Handle, 4" Wrist Action (shown)
Handle, Lever
Handle, 4-Arm
14
Screw, 4" Wrist Action (shown)
12
Screw, Lever Handle
15
Index, Snap-In Red (Hot) (shown)
Index, Lever Handle (Hot)
16
Index, Snap-In Blue (Cold) (shown)
Index, Lever Handle (Cold)
17
Pivot Action Handle - Hot
18
Pivot Action Handle - Cold
Cold Cap Assembly
Hot Cap Assembly
Lavatory Handle, 3-Wing - Cold
Lavatory Handle, 3-Wing - Hot
Fast Self-Closing Asm - Cold
Fast Self-Closing Asm - Hot
Cold Alpine Handle Assembly
Hot Alpine Handle Assembly
N/A
N/A
016749-45
016742-45
016745-45
N/A
N/A
016754-40
016847-40
000958-20
001257-40
017292-45
Opt.B
016777-45
Inquire w/ T&S
B-0199-01
B-0199-02
B-0199-03
B-LT
B-PT
001495-45
014200-45
016753-40
016767-25
016752-40
016768-25
012449-40
Opt.B
017327-40
Opt.B
238A
Opt.B
238AH-PA
Opt.B
238AC-PA
Opt.B
B-WH4
001638-45
002521-45
000925-45
000922-45
001194-45
001661-45
001686-45
001660-45
PA-H
Opt.B
PA-C
Opt.B
014195-40
Opt.B
014194-40
Opt.B
001784-40
Opt.B
001783-40
Opt.B
002875-40
Opt.B
002876-40
Opt.B
076F-C
Opt.B
076F-H
Opt.B

Publicidad

loading

Resumen de contenidos para T&S B-2300 Serie

  • Página 1 Parts List Base Faucet Assembly Side Flange Nut C-Washer 016749-45 Center Flange Nut 016742-45 Compression & Nut Fitting 016745-45 Compression Nut 8” FIXED CENTER Compression Fitting Center Shank: CONCEALED Center Shank, Swivel 016754-40 Center Shank, Rigid 016847-40 WIDESPREAD Coupling Nut 000958-20 Escutcheons: B-2300, B-2800,...
  • Página 2 Before starting the installation, be sure to flush supply lines and shut off water supply. Step 1: Step 2: Step 3: Take center shank out of body. Place hanger on body. Add center flange nut to top of Insert body into deck holes until hanger snaps to top of deck. compression nut.
  • Página 3 Installation and Maintenance Instructions Limited One Year Warranty T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one (1) year from the date of purchase.
  • Página 4 Exploded View Some items are listed for instructional purposes and may not be sold as separate parts.
  • Página 5 Part Number Guide Faucet Assemblies Asm, Rigid GN Swivel Yoke 8” CC 005973-40 Locknut, Yoke 000956-45 Washer, Swivel Yoke - Bottom 000993-45 Yoke, Swivel Washer, Yoke Star 000982-45 O-Ring, Knuckle Joint 001062-45 Nipple 000342-20 O-Ring, Swivel Yoke - Center 001068-45 Washer, Swivel Yoke - Top 000994-45 Washer, Shank...
  • Página 6 General Instructions Installation: 1. Turn off water supply and drain lines. Drill (3) three holes in sink or countertop where you are install- ing faucet assembly. See illustration below: 8” to 12” [20 to 30cm] 4” to 6” [10 to 15cm] 3.
  • Página 7 General Instructions 10. Reinstall no.19 and no.20 onto 6. Remove no.13, no.14 and no.15 no.16 at top of sink. Loosely tighten from no.16. Assemble the previous by hand. Do this for both sides. items onto arm of no.7, as shown in (Make sure greased no.8 is in place.) illustration below.
  • Página 8 General Instructions 20. Packing nut and locknut should Note: When tightening no.17 and be loosely assembled before replac- no.18, make sure that both no.16’s ing into no.21,22. Hand-tighten are located at the same height locknuts only against no.23. Do not above sink level.
  • Página 9 Instrucciones Generales Instalación: 1. Cierre la fuente de agua y desagüe las tuberias. Perfore (3) tres huecos en el lavatorio o en el mostrador donde el ensamble de canilla sera instalada. Mire la ilustración abajo: 8” to 12” [20 to 30cm] 4”...
  • Página 10 Instrucciones Generales 6. Remuéva las partes No.13, No.14 y 10. Coloque de nuevo las partes No.19 y No.15 de la parte No.16 Ensamble los No.20 en la parte No.16 sobre el lavatorio. Aprete a mano fl ojamente.Haga esto para articulos anteriores en el brazo de la parte ambos.
  • Página 11 Instrucciones Generales 20. La tuerca de empaque y la contratu- Nota: Cuando este apretando las partes erca deben ser fl ojamente ensambladas No.17 y No.18, asegurese que ambas antes de estar colocadas de nuevo en las partes No.16 esten localizadas a la partes No.21,22.
  • Página 12 Instructions Générales L’Installation: 1. Fermer la réserve de l’eau et égout- ter la tuyauterie. Percer (3)trois trous dans l’évier ou le comptoir où vous aller installer l’assemblage du robinet. Voir le diagramme ci-dessous: 8” to 12” [20 to 30cm] 4” to 6” [10 to 15cm] 3.
  • Página 13 Instructions Générales 10. Réinstaller Nº.19 et Nº.20 sur Nº.16 6. Enlever Nº.13, Nº.14 et Nº.15 de Nº.16. en haut de l’évier . Resserrer par le main Assembler les choses précédentes sur le - sans bien serrer. Faire la même chose bras de Nº.7, comme indiqué...
  • Página 14 Instructions Générales 20. L’écrou d’emballage et le contre- Noter: En resserrant Nº.17 et Nº.18, écrou devoir être assembler ap- soyez certain que les Nº.16’s , tous proximativement avant remplacer les deux se situer au même niveau dans Nº.21,22. Resserrer par le au-dessus-de l’évier .
  • Página 15 Allgemeine Anleitungen Installation: 1. Wasserzufuhr absperren und Wasserlei- tungen entleeren. 3 (drei) Löcher in den Spültisch bzw. die Abdeckplatte bohren, in die die Armaturengarnitur installiert wird. Siehe Darstellung unten: 8” to 12” [20 to 30cm] 4” to 6” [10 to 15cm] 3.
  • Página 16 Allgemeine Anleitungen 10. Nr. 19 und Nr. 20 wieder auf Nr. 16 auf der Oberseite des Waschtisches installieren. Mit der Hand leicht festdrehen. Dies für 13,14,15 beide Seiten durchführen. (Sicherstellen, daß sich gefettete Nr. 8 an der richtigen Stelle befi ndet). 6.
  • Página 17 Allgemeine Anleitungen 20. Dichtungsmutter und Gegenmutter Anmerkung: Beim Festziehen von sollten lose zusammengesetzt werden, Nr. 17 und Nr. 18 sicherstellen, daß beide bevor sie wieder in Nr. 21, Nr. 22 eing- Nr. 16 sich auf derselben Höhe über esetzt werden. Mit der Hand nur die Ge- dem Waschbecken befi...
  • Página 18 RELATED T&S BRASS PRODUCT LINE B-0865-04 Medical Lavatory Faucet Concealed Body B-0868-04 Medical Lavatory Faucet with Pop-Up Waster T&S BRASS AND BRONZE WORKS, INC. A fi rm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, T & S Brass-Europe Travelers Rest, SC 29690 ‘De Veenhoeve’...

Este manual también es adecuado para:

B-2800 serieB-2900 serie