Whispbar K991W Instrucciones De Montaje página 10

EN
Fitting Kit
K991W
Apply protective tape as shown.
Carefully remove ditch mould at the front
position with flat-head screwdriver.
Unhook rubber ditch mould from plastic
retaining clip (A) and double sided tape (B).
Lift ditch mould up and out of the channel.
Completely remove from the vehicle.
The rubber ditch mould is to be re-installed
on the vehicle later.
Turn rubber ditch mould over.
Place on a workbench.
From the bottom, cut 3/4 of the way
through the rubber ditch mould as shown.
Blade should contact steel strip.
10