Install Transition Onto Top Of Hood; Mount Hood Onto Ceiling Or Cabinet - Blomberg BCHP30100SS Manual Del Usuario

4 Installing your appliance
23 9/16 "
20 9/16"
17 9/16
14 9/16"
4.3.1 Install Transition Onto
Top of Hood
A
IMPORTANT: Remove shipping
tape from damper and check that
damper moves freely.
• Place the transition piece over the hood exhaust
and secure with 4 screws provided.
• Use duct tape to seal the connection. Check to
be sure the damper moves freely.
14 / 62 EN
48"
42"
36"
30"
4.3 2 Mount hood onto ceiling
or cabinet
C
• Drive mounting screws into the studs until
they protrude 1/4". The 1/4" gap will provide
clearance to engage the keyhole slots in the top
of the hood.
• Lift hood to installation position. Locate house
wiring and route trough the knockout (from the
back or top of the hood).
• Lift hood onto mounting screws. Slide back
against the rear wall.
• Tighten mounting screws.
A
If mounting to the underside of a
cabinet with a recessed bottom,
install shims to fill the gap.
IMPORTANT:
For additional
support and to minimize vibration
during operation, the hood must be
secured to the back wall. Use wall
anchors to fasten bottom back of
hood to the wall.
Range Hood / User Manual