3
Technical specifıcations of your appliance
3.1 List of Materials
3.1.1 Parts supplied
Removing the packaging
A
Remove carton carefully, Wear
gloves to protect against sharp
edges.
A
WARNING: Remove the protec-
tive film covering the product before
putting into operation.
• Hood canopy.
• Blower.
• Duct transition.
• Lamp already installed.
• Grease filter.
• Hardware bag with:
– Use, care and installation guide
– 2 hollow wall anchors with screws to secure
hood to the wall at the bottom
– 4 Wood screws to secure the wood support
to the wall
– 4 Phillips head screws to secure the transition
to the hood outlet on the top
– 6 Phillips head screws to secure hood to the
wood support (2 secured to wood support)
– 1 Safety screw and lock washer to secure
the blower (screw is marked with red or blue
paint)
– 2 Flat washers for wall anchors
3.1.2 Parts not supplied
Optional Accessories
• Duct Cover
• Heat Lamps kit (2 IR 175W)
• Backsplash kit
Tools/Materials required
• Wire nuts
• Tape to mount template
• 8" rounded metal duct length to suit installation
Range Hood / User Manual
• Measuring tape
• Pliers
• Gloves
• Knife
• Safety glasses
• Electric drill with 5/16" and 3/8" Bits
• Strain relief
• Spirit level
• Duct tape
• Screwdrivers:
– Phillips (Posidrive) # 2
– Torx # 2
• Wire cutter/stripper
• Masking tape
• Hammer
• Saw, jig saw or reciprocating saw
Operating mode
Max. Ventilation
Capacity
Nr.of Speeds
Controls
Lights
Filtering
Volts
Frequency
Total Power
(motor + lamps)
Plug type
Required dis-
tance above
cooktop
BCHP30100SS
ducted out only
515 CFM
4
Mechanical Knobs
2 x 50 W Halogene
2 x Baffle Filters
120 V
60 Hz
550 W
Hard Wire
30" (gas cooktop)
30" (electrical cooktop)
9 / 62 EN