Front Runner FAFF004 Instrucciones De Montaje página 3

2
FIT AND SECURE FOOT RAIL
2.1
2.2
2.3
FAFF004_REV_A00
Rivet in trim moulding
Measure 200mm towards the front of the
vehicle from the center of the rivet in the
ditch moulding shown in 2.1 and make a
mark in the roof ditch. This will be the rear
hole for the Foot Rail.
Position the Foot Rail in the ditch. Align the
rear mount hole in the Foot Rail with the rear
mark you made earlier in 2.1 and mark the
remaining five holes.
Remove the Foot Rail from the vehicle.
Drill a 5mm Pilot hole in the center of the
markings. Open the holes using a 12mm drill
bit.
5mm
12mm
Insert the M6 Button Head Bolt (Item 12) into
the one side of the Installer Wrench (Item 13).
Loosely fit a Jack Nut (Item 3) to the Button
Head Bolt as shown.
Using the Installer Wrench and a M6 x 30
Button Head Bolt, insert the M6 Jack Nuts
into all 12 holes.
Place the assembly into a hole drilled in
2.2. Using a Battery Powered Screw
Driver and a 4mm Allen Key Bit, set the
Jack Nut into the hole while holding onto the
handle of the Installer Wrench.
Make sure that the Jack Nut has pulled
up all the way to the inside skin of the
roof panel.
3 © 2020 FRONT RUNNER VEHICLE OUTFITTERS